Sanyo PDG-DHT8000L Owners Manual - Page 23
Connecting the AC Power Cord
View all Sanyo PDG-DHT8000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Connecting the AC Power Cord This projector uses nominal input voltages of 100-240 V AC. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system. If you are not sure of the type of power being supplied, consult your authorized dealer or service center. Connect the projector with all peripheral equipment before turning on the projector. A fixing bracket is provided to prevent the AC power cord from coming loose. Follow these steps to attach the fixing bracket and connect the AC power cord to the projector. 1 Fit a fixing bracket in each hole. 2 Connect the AC power cord to the projector. 3 Turn the fixing bracket to lock the AC power cord in place. (See the right figure.) CAUTION The AC outlet must be near this equipment and must be easily accessible. ✔Note: •Unplug the AC power cord or turn off the MAIN ON/OFF Switch when the projector is not in use. When the projector is in stand-by mode, it consumes a little electric power. Holes Installation Fixing bracket NOTE ON THE POWER CORD AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet, contact your sales dealer. Projector side For the U.S.A. and Canada Ground AC Outlet side For Continental Europe For the U.K. Ground To POWER CORD CONNECTOR on your projector. To the AC Outlet. (120 V AC) To the AC Outlet. (200-240 V AC) To the AC Outlet. (200-240 V AC) 23