Sanyo PDG-DHT8000L Owners Manual - Page 31

Basic Operation SHUTTER button See pages 28 and 60 for details. FILTER button Press and hold the FILTER button for more than five seconds to replace the filter mechanically. See page 56 for details. ✔Note: •The filter cannot be rewound. • When the filter is replaced, the total accumulated time of the filter use is automatically set to 0. IMAGE ADJ. button Press the IMAGE ADJ. button on the remote control to adjust an image level of the screen. For more detail, see pp.46-48. IMAGE SEL. button Press the IMAGE SEL. button on the remote control to select a desired image level of the screen. For more detail, see pp.39, 43. P-TIMER button Press the P-TIMER button on the remote control. The Timer display "00 : 00" appears on the screen and starts to count time (00 : 00-59 : 59). To stop the P-TIMER, press the P-TIMER button. To cancel the P-TIMER, press the P-TIMER button again. Remote Control SHUTTER button IMAGE ADJ. button P-TIMER button FILTER button KEYSTONE button IMAGE SEL. button ✔Note: •See the previous page for the description of other buttons. P-Timer display KEYSTONE button Press the KEYSTONE button on the remote control. The "Keystone" appears on the screen. Use the Point ed7 8 buttons to correct keystone distortion. The keystone adjustment can be stored (pp.41, 45). • The white arrows indicate that there is no correction. • A red arrow indicates the direction of correction. • An arrow disappears at the maximum correction. • If you press the KEYSTONE button on the remote control again while the Keystone dialog box is being displayed, the keystone adjustment will be canceled. •The adjustable range can be limited depending on the input signal. • "Keystone" disappears after 10 seconds. Reduce the upper width with Point e button. Reduce the lower width with Point d button. Reduce the left part with Point 7 button. Reduce the right part with Point 8 button. 31