Sanyo PDG-DHT8000L Owners Manual - Page 70
Optional Color Wheel Installation, replaced by grasping handle.
View all Sanyo PDG-DHT8000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Maintenance and Care Optional Color Wheel Installation The projector comes with the high brightness color wheels installed. Additional rich color reproduction color wheels are supplied. To replace the color wheels, refer to the following steps. 1 Turn off the projector, press the Main On/Off Switch to Off SCREW and unplug the AC power cord from the AC outlet. Let the projector cool for at least 45 minutes. LAMP 2 Loosen a screw on the Lamp Cover. Slide and open the Lamp Cover. (See the right figure.) COVER 3 Loosen three screws and pull out the color wheel to be replaced by grasping handle. 4 Replace the color wheel with a new one and tighten three screws. Make sure the color wheels are set properly. 5 Put the Lamp Cover back and tighten a screw. ✔Note: •W ait until the lamp house and the color wheel cool off. •M ake sure to install the same type of two color wheels at the same time. When different types of color wheels are installed, 'Non-matching color wheels!' message appears on the screen. Allow the projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of the projector can become very hot. COLOR WHEELS SCREWS 70