Sanyo PLC-XU300 Instruction Manual, PLC-XU300A - Page 9
Rear Terminal, S-video In, Audio In, Computer In 1 / Component In, Audio Out Variable
UPC - 086483073830
View all Sanyo PLC-XU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Rear Terminal ① ② ③ Part Names and Functions ④ L R ⑨ ⑧ ⑦ ⑥⑤ ① CONTROL PORT When the projector is controlled by a computer, connect to this jack with serial control cable. ② COMPUTER IN 1 / COMPONENT IN Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal(pp.14,16). ③ COMPUTER IN 2 / MONITOR OUT - Connect computer output to this terminal (p.14). - This terminal can be used to output the incoming analog RGB and Component signal from COMPUTER IN 1/COMPONENT IN terminal to the other monitor (pp.14,16). ④ LAN Connection Terminal Connect the LAN cable (refer to the owner's manual of "Network Set-up and Operation"). ⑤ S-VIDEO IN Connect the S-VIDEO output signal from video equipment to this jack (p.15). ⑥ AUDIO OUT (VARIABLE) Connect an external audio amplifier to this jack (pp.14-16). This terminal outputs sound from AUDIO IN terminal (⑦ or ⑧). ⑦ COMPUTER 1 / COMPUTER 2 AUDIO IN Connect the audio output (stereo) from a computer or video equipment connected to ② or ③ to this jack. (pp14, 16) ⑧ AUDIO IN Connect the audio output signal from video equipment connected to ⑤ or ⑨ to this jack. For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.15). ⑨ VIDEO IN Connect the composite video output signal to this jack (p.15).