Schwinn 245 Recumbent Bike Assembly and Owner's Manual - Page 36
Condition/Problem, Things to Check, Solution
View all Schwinn 245 Recumbent Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Condition/Problem Console shuts off (enters sleep mode) while in use Unit rocks/does not sit level Pedals loose/unit difficult to pedal Clicking sound when pedaling Seat post movement Things to Check Check electrical (wall) outlet Check connection at rear of unit Check data cable integrity Check data cable connections/orientation Reset Machine Check magnet position (requires shroud removal) Check Speed Sensor Check leveler adjustment Solution Make sure unit is plugged into a functioning wall outlet. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Magnet should be in place on pulley. Contact Customer Care for further assistance. Adjust levelers until bike is level. Check surface under unit Check pedal to crank arm connection Check crank arm to axle connection Check pedal to crank arm connection Check locking pin Check adjustment knob Adjustment may not be able to compensate for extremely uneven surfaces. Move bike to level area. Pedal should be tightened securely to crank. Ensure connection is not cross-threaded. Crank should be tightened securely to axle. Be sure cranks are connected at 180 degrees from each other. Remove pedals and reattach. Be sure adjustment pin is locked into one of the seat post adjustment holes. Be sure knob is securely tightened. 36