Seagate Personal Storage 3000LS Installation Guide
Seagate Personal Storage 3000LS Manual
 |
View all Seagate Personal Storage 3000LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Seagate Personal Storage 3000LS manual content summary:
- Seagate Personal Storage 3000LS | Installation Guide - Page 1
NOT supported with this product. Kit Components The Maxtor Personal Storage 3000LS comes complete with the components shown here. Please familiarize yourself with each of these items prior to installation. • Personal Storage 3000LS • Power Adapter • USB Interface Cable • Maxtor Limited Warranty USB - Seagate Personal Storage 3000LS | Installation Guide - Page 2
Hardware - Installation: Personal Storage Installation To connect your new Maxtor Personal Storage 3000LS to your computer, please follow these simple steps. If these steps are not performed in order, the 3000LS may not function properly. Power Cord Connections 1. Ensure that your computer is turned - Seagate Personal Storage 3000LS | Installation Guide - Page 3
1. Plug the male connector from the power cord into your electrical wall outlet. 2. Plug in the smaller end of the USB cable into the USB connection on the 3000LS. Formatting Your Drive Optional for Windows 98SE/2000/Me/XP Your Maxtor Personal Storage 3000LS drive was formatted at the factory with - Seagate Personal Storage 3000LS | Installation Guide - Page 4
used, and the drive's capacity. General Troubleshooting & FAQs: 1.The Personal Storage 3000LS does not appear on my system. • Is the drive running? Make sure all power connectors on the drive and power adapter are securely plugged in. If the drive is plugged into a power strip, try plugging
-
1 -
2 -
3 -
4
 |
 |
www.maxsupport3000LS.com
1
Pre – Installation:
Thank You
Thank you for selecting a Maxtor Personal Storage product. Please follow these
instructions to take full advantage of its features.
Handling Precautions
If these handling precautions are not followed,
damage to the Personal Storage product may
result – which may void your product warranty.
Please see the Warranty section for additional
information.
•
DO
NOT
open the product. Opening the
product will void the warranty.
•
DO
NOT
bump, jar, drop, or move this
device while in operation as it may result in
loss of data.
•
DO
NOT
stack this product more than three
units high.
•
DO
NOT
set or operate the product on its
side without an approved cradle from
Maxtor. It may fall over and damage the
internal hard drive.
•
DO
NOT
disconnect any cables or power
while copying files without properly
unplugging or unmounting the device via
your operating system – as this can result in
data loss and possible damage to the
internal hard drive.
•
DO
NOT
set any liquids or drinks on the
product – as they will damage the internal
electronics.
Hardware and Operating System
Requirements for Windows PC
•
Pentium II-class equivalent processor or higher
•
Windows 98SE, Me, 2000 or XP
•
Available USB 1.1 or USB 2.0 port
•
At least 32 MB of RAM as required by the Operating System
•
Internet connection (for Windows 98SE)
NOTE: Macintosh Systems are NOT supported with this product.
Kit Components
The Maxtor Personal Storage 3000LS comes
complete with the components shown here. Please
familiarize yourself with each of these items prior to
installation.
•
Personal Storage 3000LS
•
Power Adapter
•
USB Interface Cable
•
Maxtor Limited Warranty
USB Backward Compatibility
The Maxtor Personal Storage 3000LS is backward
compatible and can be used with current computer
systems with built-in USB 1.1 ports. If your
computer does not have USB 2.0 support built in, a
USB 2.0 PCI adapter card is required to achieve
USB 2.0 data transfer rates.