Sealey LED186 Instruction Manual

6W COB LED + 1W LED RECHARGEABLE SLIM

INSPECTION LAMP

MODEL NO:

LED186

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these

instructions, and properly maintained, give you years of trouble free performance.

1. SAFETY

1.1.

GENERAL

9

It is important to ensure that the lamp is fully charged before initial use.

8

DO NOT

turn the lamp on when it is being charged.

8

DO NOT

shine directly into your, another person’s or an animal’s eyes.

8

DO NOT

allow children to use the lamp.

8

DO NOT

leave battery in a discharged state. Recharge battery immediately.

9

Recharge the battery at least once every six months of non-use.

9

There are no user serviceable components.

DO NOT

dismantle.

8

DO NOT

pull the charger plug from the mains socket by the lead.

1.2.

BATTERY SAFETY

±

WARNING!

To reduce the risk of burns or fire:

8

DO NOT

Attempt to open, disassemble, modify or service the battery pack.

8

DO NOT

Crush, puncture, short external contacts or dispose of in fire or water.

8

DO NOT

Expose to temperatures above 60°C (140°F).

9

Recycle or dispose of used battery as stipulated by local regulation.

9

If the electrolyte in the cells gets on your skin, thoroughly wash with water. If it gets in your eyes, rinse thoroughly with cool

water and seek immediate medical attention.

2. INTRODUCTION

S

limline fold out inspection lamp for use in confined spaces with its slim 9mm thickness. Inspection arm can be rotated 180° and folded.

Features 1 COB LED, which produce up to 550 lumens and a 1W SMD LED on the end for use as a directional torch. Main light has two

different lighting modes High/Low (550lm/220lm) and the SMD spotlight which has one setting at 80lm. Suitable for hands-free operation with a

magnet and a hanging hook. Folds away, small and compact, suitable for keeping in your pocket. Powered by a 3.7V 2Ah rechargeable Li-ion

battery, which lasts up to 8 hours. Supplied with USB charging lead.

3. SPECIFICATION

Model No:

.................................................................

LED186

Battery:

..........................................................

3.7V 2Ah Li-ion

Charging Time:

..................................................................

3hr

IP Rating:

..........................................................................

IP4

LED Qty:

.......................................................

1 COB + 1 LED

Lumen Output

...............

Side(High/Low)/Top: (550/220)/80lm

Maximum Length:

......................................................

270mm

Minimum Length:

.......................................................

155mm

Operating Time:

.....................

Side(High/Low)/Top: (2.5/4)/8hr

OPERATION

4. OPERATION

4.1.

CHARGING

4.1.1.

The battery fitted to this lamp is considered to be a consumable item and its ability to accept charge will reduce over time. We will

warranty it against mechanical and electrical defect for a period of one year, this does not cover fair wear and tear. If the

battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will

not replace the battery even if it is less than one year old.

4.1.2.

Connect the charger into the USB socket on the lamp. Plug in to power supply and turn on. The blue LEDs on the lamp will light as

the battery charges. When all LEDs are lit, the torch is fully charged.

4.1.3.

When the battery has fully charged (approx 3hrs) disconnect from mains supply.

NOTE:

The Lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another

charge.

L

ED186

Issue 1

23/04/2020

Original Language Version

© Jack Sealey Limited

Refer to

instructions