Sharp CD-DH950P CD-DH950P Operation Manual - Page 11
Listening to the radio - stereo
View all Sharp CD-DH950P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Listening to the radio OPEN / CLOSE TUNER (BAND) TAPE TUNING 5 4 3 2 1 TIMER MINI COMPONENT SYSTEM CD-DH950P REMOTE SENSOR POWER ON/ STAND-BY iPod/iPhone VOL. CD TUNER (BAND) TAPE AUDIO IN USB TUNING VOL. PRESET OPEN / CLOSE 5 4 3 2 1 PRESET TUNER(BAND) TUNING ON/STAND-BY DISPLAY MENU (TV OUT) DISPLAY CD TUNER(BAND) TAPE AUDIO IN USB X-BASS TUNING BASS/TREBLE VOL FOLDER PLAY MODE PRESET ENTER CLOCK/TIMER PRESET MEMORY DEMO DIMMER CLEAR SLEEP MUTE TAPE MEMORY PRESET PRESET Q Tuning 1 Press the ON/STAND-BY button to turn the power on. 2 Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM). 3 Press the TUNING ( or ) button to tune in to the desired station. Manual tuning: Press the TUNING ( or ) button as many times as required to tune in to the desired station. Auto tuning: When the TUNING ( or ) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station. Notes: O When radio interference occurs, auto scan tuning may stop automatically at that point. O Auto scan tuning will skip weak signal stations. O To stop the auto tuning, press the TUNING ( or ) button again. To receive an FM stereo transmission: O Press the TUNER (BAND) button to display the "ST" indicator. O " " will appear when an FM broadcast is in stereo. O If the FM reception is weak, press the TUNER (BAND) button to extinguish the "ST" indicator. The reception changes to monaural, and the sound becomes clearer. Q Memorizing a station You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning) 1 Perform steps 1 - 3 in "Tuning". 2 Press the MEMORY button to enter the preset tuning saving mode. 3 Within 30 seconds, press the PRESET ( or ) button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1. 4 Within 30 seconds, press the MEMORY button to store that station in memory. If the "MEMORY" and preset number indicators disappear before the station is memorized, repeat the operation from step 2. 5 Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in the memory, the station previously memorized for that preset channel number will be erased. Note: The backup function protects the memorized stations for a few hours should there be a power failure or the AC power cord become disconnected. Q To recall a memorized station Press the PRESET ( or ) button for less than 0.5 seconds to select the desired station. Q To scan the preset stations The stations saved in the memory can be scanned automatically. (Preset memory scan) 1 Press the PRESET ( or ) button for more than 0.5 seconds. The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each. 2 Press the PRESET ( or ) button again when the desired station is located. Q To erase entire preset memory 1 Press the ON/STAND-BY button to enter the stand-by mode. 2 While pressing down the OPEN / CLOSE button and TUNING button, press the TUNER (BAND) button until "TUNER CLEAR" appears. OPEN / CLOSE TUNING TUNER (BAND) TAPE E-10