Sharp ER-A410 ER-A410 ER-A420 Operation Manual - Page 11

PRINTER The printer is a receipt/journal dual station type thermal printer, that does not require an ink ribbon or cartridge. The average life of the printer is approximately 5 million lines. When removing the printer cover, lift it from the rear as shown. When installing the printer cover, hook it on the pawls on the cabinet and shut it. Caution: The paper cutter is mounted on the printer (receipt side). Be careful not to cut yourself. Your register is shipped with the print head release lever held in the lifted up position by a white retainer. Be sure to remove this retainer (see the figure at the right) and push down the print head release lever before you use the register. Retainer Take-up spool Paper roll location Paper chute Print head release lever Print head release lever The print head can be lifted by the green lever on the right side of the printer. Pulling the lever forward, lifts the print head up. If the paper becomes jammed and you need to move the print head farther forward, you can pull the lever even further toward you and proceed with the removal of the jammed paper. Note Do not attempt to remove the paper roll with the head in the down position. This may result in damage to the printer and print head. 9