Sharp HTSB200 HT-SB200 Operation Manual - Page 15
AC power connection, Remote control - 100
UPC - 074000369399
View all Sharp HTSB200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
AC power connection After checking all the connections have been made correctly, connect the AC power cord to the AC power input jack, then to the AC outlet. ■ Using with the AC/DC adaptor 1 Plug the AC power cord into the AC/DC adaptor. 2 Plug the AC/DC adaptor cable into the DC IN jack on the speaker. 3 Plug the AC power cord into an AC outlet.The STAND- BY indicator will turn RED when AC power is applied. The power indicator will turn GREEN when the system in "ON". AC/DC Adaptor Cable 2 DC IN jack (DC 12V) LINE IN 2 RIGHT LEFT LINE IN 1 DC INPUT AC power cord AC Outlet (AC 100 - 240 V ~ 50/60 Hz) 1 3 AC/DC Adaptor Remote control HT-SB200 ■ Battery installation This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply, California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/ 1 Insert pin into the hole as shown and pull to open the battery holder. Pin Back of remote control 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. Battery holder Battery type Locking tab Polarity (+) symbol Positive (+) side up Preparation for Use Notes: ● Unplug the AC/DC adaptor from the AC outlet if the speaker will not be used for a long period of time. ● Use only the supplied AC/DC adaptor. Using other AC/DC adaptor may cause an electric shock or fire. Precautions for battery use: ● Remove the battery if the speaker will not be used for a long period of time. This will prevent potential damage due to battery leakage. 15