Sharp KB3425JS Installation Manual

Sharp KB3425JS - Insight Pro Range Manual

Sharp KB3425JS manual content summary:

  • Sharp KB3425JS | Installation Manual - Page 1
    DRAWER 30" Freestanding Range INSTALLATION MANUAL SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. CLEARANCES & DIMENSIONS
  • Sharp KB3425JS | Installation Manual - Page 2
    sure to leave these instructions with the consumer. IMPORTANT NOTES TO THE CONSUMER Keep this manual with your Operation Manual for future reference. Operation Manual. Read all and follow carefully. • Be sure your range is installed and grounded properly by a qualified installer or service technician
  • Sharp KB3425JS | Installation Manual - Page 3
    or loose drawer guides and dents inside the drawer or on the front side of the drawer. If there is any damage, do not operate the Microwave Drawer and contact your dealer or a SHARP AUTHORIZED SERVICER. IMPORTANT SAFETY INSTRUCTIONS If the information in this manual is not followed exactly
  • Sharp KB3425JS | Installation Manual - Page 4
    if an incorrect size range cord kit is used or the Installation Manual or strain relief clamp are disregarded. CAUTION Do not loosen the nuts wall receptacle (10-50R) strain relief clamp 240V 208/240 VOLT CONNECTION INSTRUCTIONS The range can be set for 208V or 214800˚V. The volstcaregwe setting
  • Sharp KB3425JS | Installation Manual - Page 5
    - follow all steps below. 4-WIRE CONNECTION INSTALLATION MANUAL Before wiring the range, review the suggested power source location drawings in Figure 2. If connecting to a 4-wire electrical system: 1 Follow the manufacturerʼs Installation Instructions supplied with the strain relief clamp and
  • Sharp KB3425JS | Installation Manual - Page 6
    INSTALLATION MANUAL ADJUSTABLE BACKSPLASH The range backsplash is adjustable so cap back slightly-no more than 1/8-inch-to facilitate installing the backsplash. Figure 14 5 Place the backsplash support brace into the back side of the backsplash. Angle as shown to insert, slide downward to rest on
  • Sharp KB3425JS | Installation Manual - Page 7
    Anti-Tip bracket must also be moved and installed with the range. Instructions are provided for installation in wood or cement fastened to either the below to locate the bracket if template is not available. INSTALLATION MANUAL 2 DRILL PILOT HOLES AND FASTEN BRACKET Drill a 1/8-inch pilot
  • Sharp KB3425JS | Installation Manual - Page 8
    to level the range and check electrical connections. See pages 2 and 3 for proper anchoring instructions. BEFORE YOU CALL FOR SERVICE Read the BEFORE YOU CALL and operating instruction sections in your Operation Manual. It may save you time and expense. The list includes common occurrences that are
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

1
INSTALLATION MANUAL
SPECIAL WARNING
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL
INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CLEARANCES & DIMENSIONS
For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in
accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.
RANGE MEASUREMENTS
......................................
2
CLEARANCES AND DIMENSIONS
..............................
2
IMPORTANT NOTES
.............................................
2
UNPACKING AND EXAMINING YOUR RANGE
.................
3
IMPORTANT SAFETY INSTRUCTIONS
.........................
3
ELECTRICAL CONNECTIONS
................................
3-5
ADJUSTABLE BACKSPLASH
...................................
6
ANTI-TIP
.......................................................
7
MODEL AND SERIAL NUMBER LOCATION
....................
8
CARE, CLEANING AND MAINTENANCE
......................
8
E
LECTRIC
R
ANGE
W
ITH
M
ICROWAVE
D
RAWER
30” Freestanding Range