Sharp LC-40LE830U LC-40LE830U LC-46LE830U LC-52LE830U LC-60LE830U Opera - Page 23

Direct Button Operation MUTE Mutes the current sound output. Press MUTE. • " " will be displayed on the screen for 30 minutes, and the sound is silenced. Changing Channels You can change channels in several ways. Method 1 Using CHr/s on the remote control unit or on the TV. Method 2 Using remote control buttons 0-9, • (DOT). Examples: To select a 1 or 2-digit channel number (e. g., Channel 5): Press 5 ENT. To select a 3-digit channel number (e. g., Channel 115): Press 1 1 5 ENT. To select a 4-digit channel number (e. g., Channel 22.1): Press 2 2 • (DOT) 1 ENT. Method 3 Selecting the program from Channel list. 1 Press INPUT on the remote control unit. • The INPUT list displays. 2 Press c/d to select "AIR" or "CABLE". • The Channel list displays. 3 Press a/b to select the desired channel, and then press ENTER. • When selecting a 1-digit channel number, it is not necessary to press 0 before the number. • When you enter 0-9 only, channel selection will be made if there is no operation within a few seconds. • If you push "0" by itself, nothing will happen. • Complete the above steps within a few seconds. • When you enter 0-9 and • (DOT), channel selection will be made if there is no operation within a few seconds. Changing Volume You can change the volume by pressing VOLk/l on the TV or on the remote control unit. • To increase the volume, press VOLk. • To decrease the volume, press VOLl. 20 Audio status Output device Speaker Output Select Fixed Variable Variable sound Mute • When "Output Select" is set to "Variable", the indicator on the screen changes as shown below. 60 • Within 30 minutes of pressing MUTE, mute can be canceled by pressing VOLk/l or MUTE. • Mute will be canceled after 30 minutes have passed. However, the TV will not suddenly output a loud sound as the volume level is set to 0 automatically. Sleep Timer Allows you to set a time when the TV automatically switches to standby. Press SLEEP. • The remaining time displays when the sleep timer has been set. • Each time you press SLEEP, the remaining time switches as shown below. Off 30 60 90 120 • When set, the time automatically starts counting down. • If you want to adjust the sleep timer, you can press SLEEP twice then change the time setting. • When it is 5 minutes before the time expires, the remaining time will start to keep appearing every minute. • Select "Off" by pressing SLEEP to cancel the sleep timer. • The TV will enter standby when the remaining time reaches 0. FLASHBACK Press FLASHBACK to switch to the previously tuned channel. • Press FLASHBACK again to switch back to the currently tuned channel. • FLASHBACK will not work if no channel has been changed after the TV is turned on. FREEZE Allows you to capture and freeze a moving image that you are watching. Press FREEZE. • A moving image is captured. • Press FREEZE again to cancel the function. • When this function is not available, "No displaying still image available." will display. • The still image automatically goes out after 30 minutes. • If you are using the freeze function and a broadcast activates the V-CHIP BLOCK, the freeze function will be canceled and a V-CHIP BLOCK message will appear. • You can have the same settings by choosing "Freeze" on the menu items. (See page 31.) • See page 32 for details on the Output Select function. 21