Sharp LC46SB54U Operation Manual - Page 27

Appendix Problem • No power PossibleSolution • Check if you pleased POWER on the remote control unit. (See page 11) If the indicator on the TV does not light up, press POWER on the TV • is the AC cord disconnected? (See page 7.) Has the power been turned on? (See page 11) Unit cannot be operated External influences such as lightning, static electricity, may cause imp/oper ope/ation. In this case, operate the unit alter fi/st turning off the power of the %/or unplugging the AC cold and replugging it in after 1 or 2 minutes. • Remote control unit does not operate Picture is cut off/with sidebar screen. • Are batteries inserted with polarity ( i , ) aligned? (See page 8) Are batteries worn out? (Replace with new batteries ) Are you using it under stlong or fluorescent lighting? Is a fluorescent light illuminated near the remote contlol sensor? Is the image position correct? (See page 20,) Are scleen mode adjustments such as picture size made correctly? (See page 15.) • Strange color, light color, or color misalignment • Adjust the picture tone (See pages 17 and 18,) Is the room too bright? The picture may look dark in a/corn that is too bright. Check the input signal setting. (See page 20) • Power is suddenly turned off • is the sleep timer set? (See page 12) Check the power cont/ol settings. (See page 19) • The unit's internal temperature has incleased Remove any objects blocking vent or clean No picture No sound Is connection to other components cor/ect? (See page 10,) • Is correct input signal source selected after connection? (See page 24) Is the cor/ect input selected? (See page 24,) • Is picture adjustment corlect? (See pages 17 and 18.) = Is "Off' selected in "Audio Only"? (See page 23.) o Is a non-compatible signal being input? (See page S0.) Is the volume too low? (See page 12) • Is "Variable" selected in "Output Select"? (See page 24) Have you pressed MUTE on the remote cont/ol unit? (See page 12) The TV sometimes makes a cracking sound This is not a malfunction. This happens when the cabinet slightly expands and contracts according to change in temperature This does not affect the %/'s performance The error message about reception ot broadcast The example of an error message displayed on a screen Failed to receive broadcast, Error code E202 No broadcast now, E208 Possible Solution • Check the antenna cable Check that the antenna is correctly setup. o Check the broadcast time in the program guide, Cautions regarding use in high and low temperature environments When the unfl is used in a low temperatu/e space (eg. room, office), the picture may leave trails or appear slightly delayed This is not a malfunction, and the unit will recover when the temperature returns to no/real. Do not leave the unit in a hot or cold location, Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as this may cause the cabinet to defo/m and the Liquid Clystal panel to malfunction, Storage temperature: 4°Fto 140°F( 20°Cto ! 6O°C) 27