Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 162
Select the erase settings., Press the [COLOR START] key or the [BLACK & WHITE START] key.
View all Sharp MX-2600N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
COPIER (1) Special Modes Erase (2) (3) OK Cancel OK Edge Erase Center Edge+Center Erase Erase Side Erase Edge Center 1/2 1/2 (0~1) (0~1) inch inch Select the erase settings. (1) Touch the desired erase mode. Select one of the four positions. Touch the [Side Erase] key to open the following screen. Erase Side Erase Up Cancel OK Erase position for Side 2 Left Right Down Same Side as Side 1 Different Side from Side 1 3 Touch the checkbox of the edge that you wish to erase and make sure that a checkmark appears. When performing 1-sided to 2-sided copying or 2-sided to 2-sided copying, set the erase edge on the reverse side. • If you touch the [Same Side as Side 1] key, the edge in the same position as on the front side will be erased. • If you touch the [Different Side from Side 1], the edge in the position opposite to the erased edge on the front side will be erased. When you have completed the erase edge settings, touch the [OK] key. (2) Set the erasure width with . 0" to 1" (0 mm to 20 mm) can be entered. (3) Touch the [OK] key. You will return to the base screen of copy mode. Press the [COLOR START] key or the [BLACK & WHITE START] key. Copying will begin. If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you have selected sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and then 4 touch the [Read-End] key. (For the second original and following originals, use the same [START] key as you did for the first original.) To cancel scanning of the original and copying... Press the [STOP] key ( ). If a ratio setting is used in combination with an erase setting, the erase width will change according to the selected ratio. For example, if the erase width setting is 1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm). To cancel the erase setting... Touch the [Cancel] key in the screen of step 3. System Settings (Administrator): Erase Width Adjustment The default erase width can be set from 0" to 1" (0 mm to 20 mm). The factory default setting is 1/2" (10 mm). 2-48 Contents