Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 424

FACSIMILE Press the [BLACK & WHITE START] key to scan the first set. 4 To cancel scanning... Press the [STOP] key ( ). Insert the next set of originals and press the [BLACK & WHITE START] key. Repeat this step until all originals have been scanned. 5 To cancel scanning... Press the [STOP] key ( ). All scanned data will be cleared. Place next original. (Pg.No.x) Press [Start]. When finished, press [Read-End]. Touch the [Read-End] key. Configure Read-End 6 • If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the transmission is reserved. • The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original page scanned. However, when Job Build is used in combination with 2in1 in the special modes, only the exposure can be changed when scanning each even-numbered page of the original pages. • If the memory becomes full during scanning, a message will appear and the transmission will be canceled. • This function cannot be used in direct transmission mode or when the speaker is used to dial. To cancel Job Build.... Touch the [Job Build] key in the screen of step 3 so that it is not highlighted. 4-83 Contents