Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 430

FACSIMILE (A) (B) XX pages of original have been scanned. Send the scanned data? (P.x) Cancel OK 5 When scanning ends, check the number of original sheets scanned and touch the [OK] key. Transmission will begin. • When Job Build mode is used, the confirmation message will appear after the [Read-End] key is touched. • The message on the screen shows the number of sheets scanned in (A), and the number of pages (sheet sides) scanned in (B). For example, if both sides of one original sheet are scanned, "1" will appear in (A) and "2" will appear in (B). If this step is not performed for one minute while the above confirmation screen appears, the scanned image and settings will be cleared and the base screen will reappear. Scanning will not be completed automatically and the image will not be reserved for transmission. If the displayed number of original sheets is different from the actual number of sheets... Touch the [Cancel] key and then touch the [OK] key in the message screen to clear all scanned data. Scan settings and destination settings will not be cleared. Insert the original sheets in the automatic document feeder again and press the [BLACK & WHITE START] key to re-scan. When original count is enabled, it is enabled in other modes as well. To cancel the Original Sheet Count function... Touch the [Original Count] key in the screen of step 3 so that it is no longer highlighted. System Settings (Administrator): Initial Original Count Setting This can be enabled to have the number of original sheets always counted. The setting can be enabled separately for each mode. 4-89 Contents