Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 725

I-Fax Settings These settings can be configured when the Internet fax expansion kit is installed. SYSTEM SETTINGS I-Fax Default Settings These settings are used to configure the default settings for Internet fax. Auto Wake Up Print When the [POWER] key ( ) is "off" (but the main power switch is "on") and an Internet fax is received, this function activates the machine and prints the fax. When this function is disabled, received Internet faxes are not printed until the [POWER] key ( ) is switched "on". Compression Setting This is used to set the default compression mode for Internet fax transmission. The settings are shown below. • MH (G3) • MMR (G4) Speaker Volume Setting This is used to adjust the volume of fax receive signals and communication error signals heard through the speaker. A fax receive signal sounds after the machine checks the mail server and retrieves received faxes. A communication error signal sounds when a delivery failed e-mail is received from the destination Internet fax machine. Transaction Report Print Select Setting This is used to select whether or not a transaction report will be printed, and if printed, the condition for being printed. Select a setting for each of the following operations: Single Sending • Print Out All Report • Print Out Error Report Only • No Printed Report Broadcasting • Print Out All Report • Print Out Error Report Only • No Printed Report Receiving • Print Out All Report • Print Out Error Report Only • No Printed Report When a transaction report is printed, you can have part of the first page of the transmitted original printed on the transaction report. For more information, see "Original Print on Transaction Report". Original Print on Transaction Report When a transaction report is printed, this is used to print part of the first page of the transmitted original on the transaction report. Select one of the settings below. • Print Out All Report • Print Out Error Report Only • No Printed Report This setting will not be effective if "Transaction Report Print Select Setting" below is set to "No Printed Report". 7-79 Contents