Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 749

SYSTEM SETTINGS Image Send Settings Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings] key to configure the settings. Fax Settings Fax Default Settings The fax settings can be enabled or disabled to suit the needs of your workplace. Dial Mode Setting Select the appropriate setting for your telephone line type. Dial Mode Setting Select the line type from the list. Auto Select Select this after the line has been connected to have the machine automatically detect whether your line is a pulse dial line or a tone dial line. Auto Wake Up Print When the [POWER] key ( ) is "off" (but the main power switch is "on") and a fax is received, this function automatically activates the machine and prints the fax. When this function is disabled, received faxes are not printed until the [POWER] key ( ) is switched "on". Pause Time Setting Use this to change the length of pauses inserted in fax numbers. If a hyphen "-" is entered when dialing or storing a fax number, a pause of 2 seconds is inserted. The pause can be changed to any number of seconds from 1 to 15. Fax Dest. Confirmation Mode This setting specifies whether or not a destination verification message is displayed when sending a fax in order to prevent accidental transmission to the wrong destination. Speaker Settings Use these settings to set the sound heard from the speaker for the Speaker, Ringer Volume, Line Monitor, Fax Receive Complete Signal, Fax Send Complete Signal, and Fax Communication Error Signal. For the Fax Receive Complete Signal, the Fax Send Complete Signal, and the Fax Communication Error Signal, the Tone Pattern and Transmission Complete Sound Time Setting can be selected in addition to the volume. Check on Setup Sounds Use this to check the selected tone pattern and volume. Remote Reception Number Setting Fax reception can be activated from an extension phone connected to the machine by entering a 1-digit number and pressing the key twice on the phone's keypad. This number is called the remote reception number, and you can set it to any number from "0" to "9". 7-103 Contents