Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 791

TROUBLESHOOTING PROBLEMS RELATED TO MACHINE OPERATION Problem Specified machine functions cannot be used. The operation panel cannot be used. Point to check Have functions been disabled by the administrator? Is the main power indicator lit? Did you just power on the machine? Is the [POWER SAVE] key ( ) blinking? Is a cover open or a device separated from the machine? Did login fail three times in a row? Does a message appear indicating that Auto Login failed? Solution Some functions may have been disabled in the system settings (administrator). Check with your administrator. When user authentication is enabled, the functions that you can use and page counts may be restricted in your user settings. Check with your administrator. If the main power indicator is not lit, make sure that the power plug is firmly inserted in the power outlet, switch the main power switch to the "on" position, and press the [POWER] key ( ) to turn on the power. After the [POWER] key ( ) is turned on, the machine requires some time to complete warmup operation. During this time functions can be selected, however, a job cannot be run. Wait until a message appears indicating that the machine is ready. Auto Power Shut-Off mode has activated. To return the machine to normal operation, press the [POWER SAVE] key ( ). ☞ 1. BEFORE USING THE MACHINE "[POWER SAVE] KEY" (page 1-16) A warning message will appear when a cover is open or a device is separated from the machine. Read the message and take appropriate action. When "A Warning when Login Fails" is enabled in the system settings (administrator) and login fails 3 times in a row, a warning will be displayed and operation will lock for 5 minutes. After operation unlocks, log in using the correct user information. (If you do not know your user information, contact your administrator.) Auto Login failed due to a problem on the network. Contact your administrator. If you are the administrator, touch the [Admin Password] key, log in as an administrator, and temporarily change the auto login settings in the system settings (administrator). (Restore the changed settings to their original state after the network problem has been solved.) 8-37 Contents