Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 729

Other Settings SYSTEM SETTINGS Copy Exposure Adjustment This is used to adjust the exposure level when [Auto] is used for the copy exposure. Select separate settings for the document glass and for the automatic document feeder. Add or Change Extra Preset Ratios Two enlargement preset ratios (101% to 200%) and two reduction preset ratios (50% to 99%) can be added. An added preset ratio can also be changed. Preset ratios other than added preset ratios cannot be changed. Card Shot Settings This is used to set the default original size for the card shot function. Both the X (horizontal) and Y (vertical) dimensions of the original can be set from 1" (25 mm) to 8-1/2" (210 mm) in increments of 1/8" (1 mm). Fit to Page Enable this setting to have the [Fit to Page] key always appear in the card shot screen. Disabling Deletion of Job Programs This is used to prohibit the deletion and changing of copy settings stored in job programs. Setting a Maximum Number of Copies This is used to set the maximum number that can be entered for the number of copies (number of continuous copies). Any number from 1 to 999 can be specified. Initial Margin Shift Setting This is used to set the default margin shift amount. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for both the front and reverse sides. Disabling of Bypass-Tray in Duplex Copy This is used to prohibit the use of the bypass tray when making two-sided copies. The bypass tray is often used to feed label sheets, transparency film, and other special media for which two-sided copying is prohibited. If a sheet of one of these special media enters the reversing unit, a misfeed or damage to the unit may result. If special media for which two-sided copying is prohibited is often used, it is recommended that you enable this setting. Erase Width Adjustment This is used to set the default erase width for erase copy. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for edge erase. Disabling of Auto Paper Selection This setting is used to disable the Auto Paper Selection function. When this is enabled and an original size is set, the same size of paper is not automatically selected. 7-73 Contents