Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 731

SYSTEM SETTINGS Network Settings Network settings are described below. Touch the [Network Settings] key to configure the settings. When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see "TURNING THE POWER ON AND OFF" (page 1-15) in "1. BEFORE USING THE MACHINE ". IPv4 Settings When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. The settings are shown below. IP Address Enter the IP address of the machine. IP Subnet Mask Enter the IP Subnet Mask. IP Gateway Enter the IP Gateway address. DHCP Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. • If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below. • If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, specify the printer port setting again and then print. IPv6 Settings When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine. The settings are shown below. Enable IPv6 Protocol Enable this setting. DHCPv6 Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. Manual Address Enter the IP address of the machine. Prefix Length Enter the prefix length (0 to 128). Default Gateway Enter the IP Gateway address. • If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below. • If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, specify the printer port setting again and then print. • In an IPv6 environment, the machine can use LPD or IPP protocol. Enable TCP/IP To use the machine on a TCP/IP network, this setting must be enabled. Enable NetWare To use the machine on a NetWare network, this setting must be enabled. Enable EtherTalk To use the machine on an EtherTalk network, this setting must be enabled. Enable NetBEUI To use the machine on a NetBEUI network, this setting must be enabled. Reset the NIC This returns all "Network Settings" to the factory default settings. Ping Command Use this function to check if the machine can communicate with a computer on the network. Specify the IP address of the desired computer and touch the [Execute] key. A message will appear indicating whether or not the computer responded. 7-75 Contents