Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 734

SYSTEM SETTINGS Image Send Settings Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings] key to configure the settings. For explanations of settings related to the fax function, see "SYSTEM SETTINGS FOR FAX" (page 7-101). Operation Settings The operation settings below apply to all image send functions. Other Settings Default Display Settings You can select one of 5 base screen types for the base screen that appears when the [IMAGE SEND] key is touched or when the [CLEAR ALL] ( ) key is pressed in image send mode. • Address Book • Scan • Internet Fax • Fax • Data Entry Hold settings for a while after scanning has been completed Use this setting to hold the settings after scanning is completed (until Auto Clear Mode activates). Switch Automatically to Copy Mode Screen Enable this setting to have the screen automatically switch to the copy mode screen if no action is taken in the image send mode screen for 20 seconds. Address Book Default Selection One of the following screens can be specified for the initial address book screen. Tab Switch • ABC • Group Address Type • All • E-mail • FTP/Desktop • Network Folder • Internet Fax (Including Direct SMTP) • Fax • Group Initial Resolution Setting The following settings are available for the default resolutions of scan, Internet fax, and fax mode. Scan : 100X100 dpi, 200X200 dpi, 300X300 dpi, 400X400 dpi, 600X600 dpi Internet fax : 200X100 dpi 200X200 dpi 200X400 dpi 400X400 dpi Half Tone 600X600 dpi Fax: Standard Fine Super Fine Half Tone Ultra Fine Apply the Resolution Set when Stored When an image stored by document filing is used, this applies the resolution setting that was stored with the image. Default Exposure Settings This is used to set the default exposure settings for scanning a document in image send mode. Select [Auto] or [Manual]. When [Manual] is selected, the exposure can be set to one of 5 levels. Default Original Image Type Select the original type beforehand to enable transmission at a resolution suitable for the original (only in scan mode and USB memory mode). The settings are shown below. • Text/Printed Photo • Text/Photo • Text • Photo • Printed Photo • Map • When the exposure is set to [Auto], a default original type cannot be selected. Moiré Reduction This reduces the moiré effect (line pattern) that occurs when printed matter is scanned (only in scan mode and USB memory mode). 7-78 Contents