Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 742

SYSTEM SETTINGS Rotation Sending Setting When transmitting an image that is one of the following sizes, this function rotates the image counterclockwise 90 degrees. (The setting can be configured separately for each size.) 5-1/2" x 8-1/2", B5, A5 Printing Page Number at Receiver When the transmitted image is printed by the receiving machine, the page number can be added to the top of each printed page. Recall in Case of Line Busy (This setting is only effective for Direct SMTP transmission.) This program is used to set the number of recall attempts and the interval between recall attempts when a transmission is not successful due to the line being busy or other reason. Number of Times to Recall When Line is Busy This setting specifies whether or not recalling is performed when the line is busy. When recalling is performed, you can set the number of recall attempts. Any number from 0 to 15 can be selected. Interval to Wait Between Recall Attempts (min.) When Line is Busy The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected. Recall in Case of Communication Error (This setting is only effective for Direct SMTP transmission.) This determines how many times your machine will automatically re-attempt the call if a fax transmission fails due to a communication error. Number of Times to Recall in Case of Error Specify how many times the machine will re-attempt the call when a communication error occurs. Any number from 0 to 15 can be selected. Interval to Wait Between Recall Attempts (min.) in Case of Error The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected. I-Fax Receive Settings I-Fax Receive Settings are described below. Auto Receive Reduce Setting When a fax is received that includes printed information such as the sender's name and address, the received image is slightly larger than the standard size. This setting is used to automatically reduce the image to fit the standard size. • If Auto Receive Reduce is disabled, the edges of the image outside the standard size will be cut off. However, the image will be clearer because it will be printed at the same size as the original. • Standard sizes are sizes such as 8-1/2" x 11" and 8-1/2" x 5-1/2" (A4 and B5). Duplex Reception Setting This is used to select whether or not received faxes are printed on both sides of the paper. When this setting is enabled and a fax consisting of 2 or more pages is received (the pages must be the same size), the pages are printed on both sides of the paper. Set Address for Data Forwarding When the machine is unable to print a received fax, the fax can be forwarded to another machine. This setting is used to configure the address of the other machine. Forwarding to Enter the forwarding address (maximum of 64 characters). Direct SMTP Select this to enable forwarding when direct SMTP is used. Add Hostname or IP Address. Select this to separately enter a host name or IP address. Hostname or IP Address When "Add Hostname or IP Address." is enabled, use this setting to enter the host name or IP address (maximum of 64 characters). Multiple forwarding addresses cannot be stored. 7-86 Contents