Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 782

TROUBLESHOOTING HOW TO REMOVE MISFEEDS If you require more information when reading the instructions in the touch panel, see the paper misfeed illustrations below. Refer to the illustration below and then go to the appropriate illustration (1 to 10) for your situation. ☞ (1): page 8-11, (2)-(8): page 8-12, (9)-(10): page 8-14 When removing a misfeed or closing a cover, tray, or the finisher, take care that your fingers do not become pinched. (1) (2)(3) (10) (1) (2)(3) (10) (4) (5) (6), (7) (4) (5) (6), (7) (8) (9) When using the MX-B402 (1) Original misfeed When using the MX-B402 Paper feed roller Open the document feeder cover and remove the paper feed roller. If it is difficult to remove misfed paper, remove the paper feed roller. To remove the paper feed roller, see "Removing the paper feed roller". Pull out the document feeder tray and remove the misfed paper. (8) (9) When using the MX-B402SC Removing the paper feed roller Lift up the knob that holds the roller shaft. Pull down the release lever. Open the automatic document feeder and remove the original. Remove the shaft rotating the roller cover upward and remove the shaft. After removing the misfeed, open and close the automatic document feeder (or the document feeding area cover or document feeder tray) to clear the misfeed display from the touch panel. 8-11 • If the roller cover is not pointing straight up when the shaft is removed, a failure may occur. • Carefully pull the misfed paper out without tearing it. Contents