Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 799
Problems Related To Transmission
View all Sharp MX-B402 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 799 highlights
TROUBLESHOOTING PROBLEMS RELATED TO TRANSMISSION Problem Transmission does not take place. Point to check Is the telephone line connected securely? Is the correct dial mode set for your line? Is a busy signal received? Did a communication error occur? Does a message appear indicating that the memory is full? Has the correct original size been set? Solution Check the telephone line jack, the wall jack, and any extension adapters to make sure that all connections are secure. ☞ CONNECTION TO THE TELEPHONE LINE (page 4-4) Ask your administrator to verify that "Dial Mode Setting" is set correctly for the line you are using. ➞ System Settings (Administrator) > "Image Send Settings" > "Fax Settings" > "Fax Default Settings" > "Dial Mode Setting" If a busy signal is received, the transmission is temporarily canceled and then automatically re-attempted after a brief interval. (Factory default setting: 2 attempts, 3 min. intervals) ➞ System Settings (Administrator) > "Image Send Settings" > "Fax Settings" > "Fax Send Settings" > "Recall in Case of Line Busy" To cancel the transmission, press the [JOB STATUS] key, touch the key of the job that you wish to cancel, and then touch the [Stop/Delete] key. If an error occurs that prevents transmission, the transmission is temporarily canceled and then automatically re-attempted after a brief interval. (Factory default setting: 3 min. intervals) ➞ System Settings (Administrator) > "Image Send Settings" > "Fax Settings" > "Fax Send Settings" > "Recall in Case of Communication Error" To cancel the transmission, press the [JOB STATUS] key, touch the key of the job that you wish to cancel, and then touch the [Stop/Delete] key. The machine supports error correction mode (ECM) and is configured to automatically resend any part of a fax that is distorted due to noise on the line. ➞ System Settings (Administrator) > "Image Send Settings" > "Fax Settings" > "Fax Default Settings" > "ECM" If the memory becomes full, the transmission canceled. Divide the originals into sets and separately, or use direct transmission. When an original is placed, the detected original size is displayed. If the original size displayed in this key is different from the size of the original you placed, be sure to touch this key and specify the correct size. 8-28 Contents