Sharp MX-M200D Operation Manual - Page 30
Indicators And Display Messages - developer
View all Sharp MX-M200D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
INDICATORS AND DISPLAY MESSAGES If one of the following messages appears in the display, take prompt action as instructed by the message. Message (Maintenance icon) Action It is time for regular maintenance. Contact your authorised service representative. (Developer replacement required Developer is required. Contact your authorised service representative as icon) soon as possible. Maintenance required. Call for service. Call for service. - (Toner cartridge replacement required icon) Maintenance required soon. Contact your authorised service representative. Turn off the power and then turn it back on. If this does not clear the message, write down the 2-digit main code and 2-digit sub-code (" - "), turn off the power, and promptly contact your authorised service representative. The toner cartridge must be replaced soon. Check the toner cartridge. Check to see if the toner cartridge has been installed properly. Remove paper from the output tray The number of sheets in the output tray (centre tray or top tray) has and press [OK]. reached the limit. Remove the paper. Load < > paper into tray < >. The paper size specified for the tray is different from the actual size. (Page 21) Memory is full. The memory became full while scanning the originals. Press the [START] key ( ) to copy only the originals that have been scanned, or press the [CA] key to cancel the job. An optional memory board (AR-SM5) can be installed to increase the original scanning capacity. Memory can be expanded to a maximum of 272 MB (256 MB of expansion memory). < >: Tray number < >: Size of paper that should be loaded 28