Sharp MX-M200D Operation Manual - Page 35
Misfeed In Tray 1
View all Sharp MX-M200D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
TROUBLESHOOTING AND MAINTENANCE Misfeed in C 1 Lower (1) in the illustration, open the fusing unit paper guide, and remove the misfed paper. Be careful not to tear the misfed paper during removal. 3 Close the side cover. The message " Clear paper path." will be cleared and copying will be possible. (1) Warning The fusing unit is hot. Do not touch the fusing unit when removing misfed paper. Doing so may cause a burn or injury. 2 If the misfed paper cannot be removed by the previous step, remove it from the paper output area. Be careful not to tear the misfed paper during removal. Note • When closing the side cover, hold the handle. • If the paper was torn, make sure that no torn pieces remain in the machine. • If the message does not clear, check again to make sure that no pieces of paper remain. 2 MISFEED IN TRAY 1 Note Make sure that there is no misfed paper in the tray before pulling it out. (Page 31) 1 Pull out tray 1 and remove the misfed paper. Be careful not to tear the misfed paper during removal. 3 Gently push tray 1 into the machine. Push the tray in completely. 2 Open and close the side cover. The message " Clear paper path." will be cleared and copying will be possible. Note • When closing the side cover, hold the handle. • If the message does not clear, check again to make sure that no pieces of paper remain. 33