Sharp MX-M450N Operation Manual - Page 40

LOADING PAPER Loading paper in the multi purpose drawer The method of loading paper into the multipurpose drawer is the same as for paper tray 1 described on page 2-2. For specifications of paper, see page 2-3. When loading envelopes, postcards or transparency film, follow the descriptions below. ● Two maximum height lines are indicated: one for plain paper and one for special paper. Maximum height line for plain paper Do not exceed this line when loading plain paper. Maximum height line special paper (red line) Do not exceed this line when loading special paper. ■ How to change the paper size To change the paper size or paper type when paper is loaded into the multi purpose drawer, refer to page 2-5 for details. ■ Setting envelopes or postcards When setting envelopes or postcards in the multi purpose drawer, set them in the orientation shown below. Loading postcards Load postcards print side up to the rear left of the tray as shown. Loading envelopes Envelopes can only be printed on the address side. Be sure to place envelopes with the address side up and the top of the envelope to the rear. Printing onto envelopes or postcards ● Attempting to print onto both sides of envelopes or postcards may result in misfeeds or poor prints. ● Do not use paper that has already been printed on by a thermal transfer or inkjet printer. In particular, paper that has been printed on by a thermal transfer printer (such as a word processor that uses a cassette) may cause missing characters and smudges. ● To avoid wrinkling, misfeeds or poor printing, make sure the postcard or envelopes stock is not curled. 2-8