Sharp MX-M450N Operation Manual - Page 65

FINISHER The finisher can deliver collated sets either stapled or unstapled. Unstapled sets can be offset stacked from the previous set for easy separation of the sets. Part names Latch Release the latch to open the finisher for misfeed removal. Top cover Open for misfeed removal. Top tray Printer, copier and fax output can be delivered here. To print onto large paper (11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3 or B4), extend the tray. Staple box Pull the box out to replace the staple cartridge or to remove staples. jammed Offset tray Stapled sets or sets to be offset will be delivered 3 here. NOTES ● Do not put pressure on the finisher (particularly each tray). ● Do not place anything on the top cover. Doing so will interfere with the machine's paper handling during duplex printing. ● The tray moves up and down during operation. Be careful not to impede its movement. ● The finisher requires the installation of other peripheral devices in order to be functional and cannot be installed together with some other devices. The table on page 8-4 shows the configurations which are compatible. Specifications Name Finisher (AR-FN6) Number of trays 2 Paper output Print face down Tray type Top tray: normal tray, Lower tray: offset tray Tray capacity Top tray: 500 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2) Lower tray: 750 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m2) Paper sizes Top tray: same as the specifications of paper for feeding in the main unit Lower tray: Max. 8-1/2" x 11" or A4, Min. B5 Paper weight Top tray: same as the specifications of paper for feeding in the main unit Lower tray: 16 to 34 lbs. or 60 to 128 g/m2 Paper types Top tray: same as the specifications of paper for feeding in the main unit Lower tray: plain paper only Tray full detection Provided in both the top tray and the lower tray Offset function Provided for the lower tray only. The offset amount is approx. 1 inch (25 mm) Paper sizes for stapling 8-1/2" x 11", A4, and B5 Stapling capacity 30 sheets* (8-1/2" x 11" or A4 or smaller 20 lbs. or 80 g/m2) *Up two sheets of cover stock (34 lbs. or 128 g/m2) can be included. Staples Single staple can be placed in the top left or lower left corners or two staples can be centered on the left side Power supply Supplied from machine Dimensions 18-5/8"* (W) x 20-7/8" (D) x 20" (H) (473 mm* (W) x 530 mm (D) x 508 mm (H)) * When the top tray is extended. Weight Approx. 46.3 lbs. (21 kg) Specifications are subject to change for improvement without notice. Supplies AR-SC1 staple cartridges must be used for this finisher. The cartridge package contains three cartridges approx. 3000 staples each. 3-7