Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 105

BEFORE USING THE MACHINE Alarm display If the [START] key indicator on the inserter operation panel is blinking and the [PUNCH] key or [STAPLE] key indicator is also blinking or solidly lit, operation will not start when the [START] key is pressed. Resolve the problem as indicated below, depending how the indicators are lit or blinking. [PUNCH] indicator [STAPLE] indicator [START] indicator Cause Solution Any one of the indicators is solidly lit. Blinks red - - - - Solidly lit Blinks red Blinking - - - - Blinks red Any one of the - indicators is blinking. - Blinks red - - - - Blinking Blinks red A paper size that cannot be fed Use paper that is a suitable size has been loaded. for punching, stapling, or saddle stitching (page 1-62). The paper type of the inserter is Heavy paper cannot be used. set to heavy paper. The finisher or saddle stitch finisher tray is full. Remove the paper from the tray. The hole punch scrap container in the punch module on the finisher or saddle stitch finisher is full. Discard the hole punch scrap (page 1-55). The finisher or saddle stitch finisher tray is full. Remove the paper from the tray. The finisher or saddle stitch finisher is out of staples. Replace the staple cartridge (page 1-52). The saddle stitch tray on the saddle stitch finisher is full. Remove the paper from the saddle stitch tray. The saddle stitch finisher is out Replace the saddle stitch staple of saddle stitch staples. cartridge (page 1-54). 1-64 Contents