Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 615

SCANNER/INTERNET FAX Scan/Special Modes Blank Page Skip (1) (2) OK Cancel OK 4 Skip Blank Page Skip Blank and Back Shadow Set blank page skipping. (1) Select the type of blank page to be skipped. Select from two types. To include blank pages on which the content on the opposite side shows through, touch [Skip Blank and Back Shadow]. (2) Touch the [OK] key. Press the [START] key. Scanning begins. • If the original was placed on the document glass, replace it with the next original and press the [START] key. When all 5 originals have been scanned, touch the [Read-End] key on the touch panel. A beep sounds and the transmission is completed. • If the original was inserted in the document feeder tray, a beep will sound when scanning is completed and transmission will take place. (A) (B) 6 XX pages of original have (P.x) been scanned. YY sheets of original will be Perform the job? Cancel OK (C) When scanning is completed, check the number of original sheets and the number of sheets to be sent, and touch [OK]. Scanning begins. • When Job Build mode is used, the confirmation message will appear after the [Read-End] key is touched. • The number of scanned original sheets appears in (A), the number of scanned sides in (B), and the number of sheets to be sent excluding blank pages in (C). For example, if five original sheets that include two blank pages are scanned by duplex scanning, (A) will show "5", (B) will show "10", and (C) will show "8". If this step is not performed for one minute while the above confirmation screen appears, the scanned image and settings will be cleared and the base screen will reappear. Scanning will not be completed automatically and the image will not be reserved for transmission. To cancel the Blank Page Skip function... Touch the [Cancel] key in the screen of step 4 so that it is no longer highlighted. System settings (administrator): Original Feeding Mode Use this setting to always skip blank pages when sending. 5-97 Contents