Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 771

SYSTEM SETTINGS Device Control These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings. Other Settings Original Feeding Mode The following original feeding modes can be set to operate by default in copy, Scan to HDD, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it. • Mixed Size Original (Same Width (Copy mode only)/Different Width) • Slow Scan Mode • Blank Page Skip (image send*) * Excluding fax mode and Internet fax mode. Saddle Stitch Position Adjust (When a saddle stitch finisher is installed.) When a saddle stitch finisher is installed, this setting is used to adjust the stapling position (folding position) of the pamphlet staple function. The value can be adjusted in increments of 0.2 mm within a range of ±5.0 mm from the home position of each paper size. Max. + 5 mm Position moved in the plus direction. Min. - 5 mm Position moved in the minus direction. 1 2 12 11 Reference position Auto Paper Selection Setting The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings: • Plain Paper • Plain and Recycle Paper • Recycle Paper The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting. * The paper type set for each paper tray using "Paper Tray Settings" (page 7-13) in the system settings (general). Tandem Connection Setting When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number and IP address of the machine used as the tandem slave machine. Disabling of Master Machine Mode To prohibit tandem transmission, enable this setting. (There is normally no need to enable this setting.) Disabling of Slave Machine Mode To prohibit tandem reception, enable this setting. (There is normally no need to enable this setting.) • The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change the port number. • To use the tandem function when user authentication is enabled, the same login name and password must be used on both the master machine and slave machine. If the same login name and password are not used, the page count may not be added to the appropriate user count or only the master machine may print. 7-69 Contents