Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 84
Important Points When Using The Bypass Tray
View all Sharp MX-M623 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
BEFORE USING THE MACHINE IMPORTANT POINTS WHEN USING THE BYPASS TRAY • When using plain paper other than SHARP standard paper or special media other than SHARP-recommended transparency film, or when printing on the reverse side of previously used paper, the paper must be loaded one sheet at a time. Loading more than one sheet at a time will cause misfeeds. • Before loading paper, straighten any curling in the paper. • When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result. Inserting paper Place paper that is 7-1/4" x 10-1/2" (A5) or smaller in the horizontal orientation. Inserting tab paper To print on tab paper, load tab paper in the bypass tray with the print side face up. Face up • Use only tab paper that is made of paper. Tab paper made of a material other than paper (film, etc.) cannot be used. • To print on the tabs of tab paper... In copy mode, use "Tab Copy" in the special modes. In print mode, use the tab print function. Inserting transparency film • Use SHARP-recommended transparency film. When inserting transparency film in the bypass tray, the rounded corner should be facing the front left of the machine. • When loading multiple sheets of transparency film in the bypass tray, be sure to fan the sheets several times before loading. • When printing on transparency film, be sure to remove each sheet as it exits the machine. Allowing sheets to stack in the output tray may result in curling. 1-43 Contents