Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 86

BEFORE USING THE MACHINE Make sure an original does not remain on the document glass. Open the automatic document feeder, make sure that an 1 original is not on the document glass, and then gently close the automatic document feeder. Adjust the original guides to the size of the originals. 2 Place the original. Make sure the edges of the originals are even. Insert the originals face up all the way into the document feeder tray. 3 Original size Insert a number of originals that does not exceed the indicator detector line on the document feeder tray. Up to 150 sheets can be inserted. Be sure to remove originals that have been finished scanning from the original exit tray. • Originals of different sizes can be placed together in the automatic document feeder. In this case, select "Mixed Size Original" in the special modes of the mode you are using. • Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips. • If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making copies. Otherwise the interior of the document feeder or the document glass may be soiled. • Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result. Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be damaged, crumpled, folded, loosely pasted together, or have cut-out holes. Originals with multiple punched holes other than two-hole or three-hole punched paper may not feed correctly. • When using originals with two or three holes, place them so that the punched edge is at a position away from the feed slot of the document feeder tray. Feed slot Hole positions 1-45 Contents