Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 96
Disposal of hole punch scrap when the punch module is installed
View all Sharp MX-M623 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
BEFORE USING THE MACHINE Return the saddle stitch holder and the saddle stitch unit to their respective 5 original positions. Make sure that the finisher is firmly attached to the machine and that 11" x 17", 6 8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or B4) size paper is loaded. If one of the above paper sizes is not set, test stapling cannot be performed. Close the lower cover of the finisher. Test stapling is automatically performed on a blank sheet. This operation is carried out to avoid blank stapling. 7 If test stapling fails to take place, repeat steps 1 to 7. Disposal of hole punch scrap (when the punch module is installed) Open the front cover of the finisher. 1 Holding the black handle, slide out the case containing the paper bits, and 2 dispose of them properly. 3 Return the waste case to its original position. 4 Close the front cover of the finifher. 1-55 Contents