Sharp R1874T R-1874 , R-1875 Microwave Operation Manual - Page 28
Light, Charcoal Filter, Oven Light - installation
View all Sharp R1874T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
CLEANING AND CARE FAN The fan will automatically start when heat rises from range surface units or burners and when convection, high mix, low mix or the broil settings are used. This protects the microwave oven from excessive temperature rise. The fan will stay on until the temperature decreases. It cannot be turned off manually during this time. For other uses, select either high or low speed. PRECAUTIONS FOR PROPER USE: 1. DO NOT leave range unattended while using high temperatures. Automatic fan may start and provide excessive air to the surface units. This may cause spattering or boilover. 2. Avoid burning food. 3. Keep grease filters clean. LIGHT 1. To replace light bulbs, first disconnect power to the oven at the circuit breaker panel or by unplugging. 2. To release cover remove the screw on the light cover. (See illustration.) 3. Replace bulbs only with equivalent watt bulbs available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS. 4. Close light cover and secure with screw removed in step 2. CAUTION: Light cover may become very hot. Do not touch glass when light is on. Do not use light for long time use such as a night light. CHARCOAL FILTER Charcoal Filter, Sharp Part Number RK-220 is used for No-vented, recirculated installation. The filter should be changed every 6 to 12 months depending on use. 1. Disconnect power to the oven at the circuit breaker panel or by unplugging. 2. Remove 3 screws that secure louver. 3. Remove louver by inserting flat edge screwdriver over each tab depressing the tab down and moving louver away from unit. 4. Pull the louver away from the oven. 5. Slide Charcoal Filter into position on support tabs. 6. Push louver back into place and gently snap tabs into place by hand (engaging both the bottom and top tabs) and replace the 3 screws to secure louver. OVEN LIGHT Remove the louver per instructions 1-4 above and charcoal filter, if used. 5. Slide the light cover forward and lift up. 6. Remove old light bulb and replace only with an equivalent watt bulb available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS. 7. Replace the oven light cover and charcoal filter, if used; push louver back in place (engaging both the bottom and top tabs) and replace the louver mounting screws. Screw Charcoal filter Top tab Light cover Screw Light bulbs Oven light 27 Screw Screw Louver Bottom tab