Sharp VLAH150U Operation Manual - Page 20

Preparation Preparation Installing the Lithium Memory Battery The supplied lithium battery is used to store the memory of the date and time settings. 1 Slide the cassette compartment door release and open the cassette compartment door. 5 Close the cassette compartment door by pressing the center until it clicks into place. Cassette compartment door release Note: The cassette holder will extend and open when the VIEWCAM is connected to a power source. Be sure to close the cassette holder before proceeding to the next step (see page 10). 2 Pull out the lithium battery holder using a pointed object such as the tip of a ballpoint pen. Lithium battery holder 3 Insert the lithium battery into the battery holder with the ` side of the battery facing the j side of the holder. j mark Removing the Lithium Battery Perform steps 1 and 2 above, then lift out the battery from the battery holder. Note: • Replace the battery with a new CR2025 battery when the date and time indicator starts to fall behind the correct time. Notes on the Use of the Lithium Battery REPLACE BATTERY WITH TOSHIBA, MATSUSHITA OR HITACHI MAXELL TYPE CR2025 ONLY. USE OF A DIFFERENT BATTERY MAY PRESENT A RISK OF FIRE OR EXPLOSION. WARNING KEEP THIS BATTERY AWAY FROM CHILDREN. IF SWALLOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT. CAUTION BATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE. • Do not short-circuit, recharge, disassemble, or heat the lithium battery. • Should the lithium battery leak, wipe the battery compartment and holder clean, and then insert a new battery. • The lithium battery will last about one year of normal usage. 4 Push the battery holder back into position. 11