Sharp VLAH150U Operation Manual - Page 50

Useful Features Tape Counter Feature The tape counter shows elapsed playback or recording time in hours, minutes and seconds. (The counter continues to count internally even while it is not being displayed.) This feature can be set and used in both VCR and Camera modes. Using the Counter VCR mode 1 Press the MENU button until appears. GAMA COUEFF. NTER SEARCH 2 Press the COUNTER button (D) to display the tape counter. COUNTER Tape counter 0 11 20 GAMA COU - MEM- RE - SEE F F . NTER ORY SE T ARCH 3 Press the MENU button until appears, then begin playback. • You can check the playback time with the tape counter. Camera mode 1 Press the MENU button until appears. 2 Press the COUNTER button (B) to display the tape counter. 3 Press the REC START/STOP button to begin recording. • You can check the recording time with the tape counter. Notes: • The counter reading may differ slightly from the actual time. This is especially noticeable when the tape has been rewound or fast forwarded a number of times, in which case there can be a difference of several seconds. • The tape counter feature will be canceled if the power source is interrupted. To turn off the tape counter Perform step 1 above, and press the COUNTER button. To reset the counter to zero During playback (or recording), perform steps 1 and 2 above, then press the RESET button at the point where you wish to reset the counter to zero. The counter will indicate 0:00.00. VCR mode RESE T 0 11 24 REW P LAY FF STOP ST I LL 0 00 00 GAMA COU - MEM- RE - SEE F F. NTER ORY SE T ARCH Useful Features 41