Sharp XG-P25X XG-P25X Operation Manual - Page 17
Using the Remote Control - projector
View all Sharp XG-P25X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Important Information Using the Remote Control Inserting the batteries 1 Press the tab and lift open the battery cover in the direction of the arrow. 2 Insert two R-6 batteries ("AA" size, UM/SUM-3, HP-7 or similar), making sure the polarities match the and marks inside the battery compartment. 3 Insert the tabs on the end of the battery cover into their slots and press the cover into position. Battery cover Battery compartment Battery cover Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below. CAUTION • Insert the batteries making sure the polarities correctly match the םand מmarks inside the battery compartment. • Batteries of different types have different properties, therefore do not mix batteries of different types. • Do not mix new and old batteries. This may shorten the life of new batteries of may cause old batteries to leak. • Remove the batteries from the remote control once they have run out, as leaving them can cause them to leak. Battery fluid from leaked batteries is harmful to your skin, therefore be sure to first wipe them and then remove them using a cloth. • The batteries included with this projector may be used up over a short period, depending on how they are kept. Be sure to replace them as soon as possible with new batteries. • Remove the batteries from the remote control if you will not be using the remote control for a long time. Available Range of the Remote Control The remote control can be used to control the projector within the ranges shown in the illustration. • The signal from the remote control can be reflected off a screen for easy operation. However, the effective distance of the signal may differ due to the screen material. When using the remote control: • Be sure not to drop, expose to moisture or high temperature. • The remote control may malfunction under a fluorescent lamp. Under that circumstance, move the projector away from the fluorescent lamp. 23Ј (7 m) 30˚ 45˚ 30˚ 45˚ 30˚ Using as a Wired Remote Control When the remote control cannot be used due to the range or positioning of the projector (rear projection, etc.), connect a ø3.5 mm minijack cable (commercially available) from the wired RC jack on the bottom of the remote control to the WIRED REMOTE control input terminal on the rear of the projector. ø3.5 mm minijack cable (commercially available) XG-P25X/CD (E)-a 14 02.3.19, 7:17 PM E-14