Sharp XG-P25X XG-P25X Operation Manual - Page 26
Using the Adjustment Feet, Using the Lens Shift
View all Sharp XG-P25X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Setting Up the Screen Using the Adjustment Feet 1 2 3 Setup & Connections Press foot releases. Adjust height of projector and remove hands from foot releases. UP DOWN Rotate feet to make minor changes. • The projector is adjustable up to approximately 10° from the standard position. • When the height of the projector is adjusted, the image may become distorted (keystoned), depending on the relative positions of the projector and the screen. CAUTION • Do not press the foot releases when the adjustment feet are extended without firmly holding the projector. • Do not hold the lens when lifting or lowering the projector. • When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the projector. Using the Lens Shift The picture can be adjusted within the shift range of the lens by rotating the dial on the top of the projector. Projector Projected Image Lens shift dial UP UP DOWN DOWN • The lens shift dial is set to the upper most position at the factory. Remember to adjust lower by turning the dial when operating the projector. • The lens shift dial has two points to help orient the position. The center of the lens and bottom of the screen are the same height (10:0) and the center of the lens and center of the screen are the same height (5:5). When either position is reached by turning the dial, you will notice a slight latching feeling. • Do not forcefully turn the lens shift dial beyond the 10:0 and 5:5 orientating positions; doing so may result in damaging the equipment. • When the AN-P9MX of optional lens is attached, lens shift cannot be used. E-23 XG-P25X/CD (E)-b 23 02.3.19, 7:04 PM