Sony CCD TRV68 Operating Instructions - Page 57
Troubleshooting, Types of trouble and their solutions
UPC - 027242586130
View all Sony CCD TRV68 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Troubleshooting - Troubleshooting - Types of trouble and their solutions If you run into any problem using your camcorder, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. If "C:ss:ss" appears on the screen, the self-diagnosis display function has worked. See page 61. In the recording mode Symptom Cause and/or Corrective Actions START/STOP does not operate. • The POWER switch is set to OFF (CHARGE) or PLAYER. c Set it to CAMERA. (p. 20) • The tape has run out. c Rewind the tape or insert a new one. (p. 19, 29) • The write-protect tab is set to expose the red mark. c Use a new tape or slide the tab. (p. 19) • The tape is stuck to the drum (moisture condensation). c Remove the cassette and leave your camcorder for at least 1 hour to acclimatize. (p. 67) The power goes off. • While being operated in CAMERA mode, your camcorder has been in the standby mode for more than 5 minutes. c Set the POWER switch to OFF (CHARGE) and then to CAMERA again. (p. 20) • The battery pack is dead or nearly dead. c Install a fully charged battery pack. (p. 11, 12) The image on the viewfinder screen • The viewfinder lens is not adjusted. is not clear. c Adjust the viewfinder lens. (p. 24) The SteadyShot function does not work. (CCD-TRV68/TRV78/TRV88/ TRV98 only) • STEADYSHOT is set to OFF in the menu settings. c Set it to ON. (p. 52) • The SteadyShot function does not work when the wide mode is set to 16:9FULL. The autofocusing function does not work. • FOCUS is set to MANUAL. c Set it to AUTO. (p. 42) • Shooting conditions are not suitable for autofocus. c Set FOCUS to MANUAL to focus manually. (p. 42) The x indicator flashes in the viewfinder. • The video heads may be dirty. c Clean the heads using the Sony V8-25CLD cleaning cassette (optional). (p. 68) The picture does not appear in the viewfinder. • The LCD panel is open. c Close the LCD panel. (p. 21) A vertical band appears when you shoot a subject such as lights or a candle flame against a dark background. • The contrast between the subject and background is too high. This is not a malfunction. A vertical band appears when you shoot a very bright subject. • This is not a malfunction. (Continued on the following page) 57