Sony CDX-L250 Primary User Manual

Sony CDX-L250 - Fm/am Compact Disc Player Manual

Sony CDX-L250 manual content summary:

  • Sony CDX-L250 | Primary User Manual - Page 1
    Player Operating Instructions Owner's Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. CDX-L250 Serial No. For installation
  • Sony CDX-L250 | Primary User Manual - Page 2
    •If your car was parked in direct sunlight, allow the unit to cool off before operating it. •Power antennas will extend automatically while the unit is operating. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer
  • Sony CDX-L250 | Primary User Manual - Page 3
    CDX-L250 1 Volume +/- button 2 MODE button 3 SRC (SOURCE) (TUNER/CD installing in a car CD Player Playing a disc Insert the disc (labeled side up). Display items When the disc/track changes, any prerecorded title of the new disc/track is automatically displayed. Source Displayable items • Clock
  • Sony CDX-L250 | Primary User Manual - Page 4
    station you want to listen to, press either side of (SEEK/AMS) until the desired frequency appears (manual tuning). Troubleshooting The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating
  • 1
  • 2
  • 3
  • 4

Operating Instructions
Sony Corporation
2001
Printed in Korea
FM
/
AM
Compact Disc
Player
CDX-L250
For installation and connections, see the supplied installation/connections
manual.
Owner’s Record
The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.
Model No. CDX-L250
Serial No.
Welcome !
Thank you for purchasing this Sony Compact
Disc Player. You can enjoy its various features.
Warning
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
CAUTION
The use of optical instruments with this product
will increase eye hazard.
Getting Started
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.
Note
Pressing the reset button will erase the clock setting
and some stored contents.
Reset button
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
22 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
5 % total harmonic distortion.
CD player section
Signal-to-noise ratio
90 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Laser Diode Properties
Material
GaAlAs
Wavelength
780 nm
Emission Duration
Continuous
Laser output power
Less than 44.6 µW
*
*
This output is the value measured at a distance of
200 mm from the objective lens surface on the
Optical Pick-up Block.
Tuner section
FM
Tuning range
87.5 – 107.9 MHz
Antenna terminal
External antenna connector
Intermediate frequency
10.7 MHz
Usable sensitivity
11 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
65 dB (stereo),
68 dB (mono)
Harmonic distortion at 1 kHz
0.7 % (stereo),
0.5 % (mono)
Separation
33 dB at 1 kHz
Frequency response
30 – 15,000 Hz
AM
Tuning range
530 – 1,710 kHz
Antenna terminal
External antenna connector
Intermediate frequency
10.7 MHz/450 kHz
Sensitivity
30 µV
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 – 8 ohms
Maximum power output
45 W
×
4 (at 4 ohms)
General
Outputs
Audio output
Power amplifier control
Power antenna relay control
Tone controls
Bass ±10 dB at 20 Hz
Treble ±10 dB at 20 kHz
Power requirements
12 V DC car battery
(negative earth)
Dimensions
Approx.
178
×
50
×
176
mm
(7
1
/
8
×
2
×
7 in.)
(w/h/d)
Mounting dimensions
Approx. 182
×
53
×
161 mm
(7
1
/
4
×
2
1
/
8
×
6
3
/
8
in.)
(w/h/d)
Mass
Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessory
Parts for installation and
connections (1 set)
Design and specifications are subject to change
without notice.
3-227-610-
11
(1)
Setting the clock
The clock uses a 12-hour digital indication.
Example: To set the clock to 10:08
1
Press
(DSPL)
for 2 seconds.
The hour indication flashes.
1
Press either side of the volume +/–
button to set the hour.
2
Press
(SEL)
.
The minute indication flashes.
3
Press either side of the volume +/–
button to set
the minute.
2
Press
(DSPL)
.
The clock starts. After the clock setting is
completed, the display returns to normal
play mode.