Sony DCR-DVD710 Operating Guide - Page 22

Step 2: Charging the battery pack (Continued) To remove the battery pack 1 Turn the POWER switch to OFF (CHG). 2 Slide the BATT (battery) release lever (1) and remove the battery pack (2). Remaining battery (approx.) BATT (battery) release lever b Notes • When you remove the battery pack or the AC Adaptor, make sure that the (Movie) lamp/ (Still) lamp (p. 25)/ACCESS lamp (p. 30)/ access lamp (p. 32) are turned off. • When you store the battery pack, fully discharge the battery before storing it for an extended period (p. 119). To use a power source from a wall outlet (wall socket) Make the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To check the remaining battery (Battery Info) Set the POWER switch to OFF (CHG), then press DISP/BATT INFO. After a while, the approximate recordable time and battery information appear for about 7 seconds. You can view the battery information for up to 20 seconds by pressing DISP/BATT INFO again while the information is displayed. 22 Recording capacity (approx.) Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FH40 125 (supplied) NP-FH50 135 NP-FH70 170 NP-FH100 390 Recording time Approximate time (min.) available when you use a fully charged battery pack. When recording on the internal memory (DCR-DVD810) or a "Memory Stick PRO Duo" DCR-DVD610 Battery pack NP-FH40 (supplied) NP-FH50 NP-FH70 NP-FH100 Continuous recording time 110 120 130 140 280 300 625 680 Typical recording time* 50 55 60 65 130 140 300 325