Sony DSC F828 Operating Instructions - Page 120
Shooting still images / movies, P, S, A, M, SCN or - lcd
UPC - 027242634237
View all Sony DSC F828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Symptom The battery remaining indicator is incorrect, or sufficient battery remaining indicator is displayed but the power runs out soon. The battery pack runs down too quickly. You cannot turn on the camera. The power turns off suddenly. Cause Solution • You have used the camera for a long time in an extremely hot or an extremely cold location. • A deviation has occurred in the remaining battery time. • The battery pack is discharged. • The battery pack is dead (page 147). p See page 146. p Charge the battery pack after using it completely. The battery remaining indicator displays the correct time (page 15). p Install a charged battery pack (page 14). p Replace the battery pack with a new one. • You have used the camera in an extremely cold location. • The DC plug is dirty so the battery pack is not charged enough. • The battery pack is dead (page 147). p See page 146. p Clean the DC plug with a cotton bud, etc., and charge the battery pack (page 143). p Replace the battery pack with a new one. • The battery pack is not installed correctly. • The AC Adaptor is disconnected. • The AC Adaptor has malfunctioned. • The battery pack is discharged. • The battery pack is dead (page 147). p Install the battery pack correctly (page 14). p Properly connect the AC Adaptor (page 17). p Consult your Sony dealer or local authorized Sony service facility. p Install a charged battery pack (page 14). p Replace the battery pack with a new one. • If you do not operate the camera for about three minutes when using a battery pack, the camera turns off automatically to prevent wearing down the battery (page 18). • The battery pack is discharged. p Turn on the camera again (page 18) or use the AC Adaptor (page 17). p Replace it with a charged battery pack (page 14). Shooting still images / movies Symptom The LCD screen is not turned on even when the power is turned on. The subject is not visible on the finder. The subject is not visible on the screen. Cause • The FINDER/LCD switch is set to FINDER. Solution p Set it to LCD (page 29). • The diopter scale is not properly adjusted. p Adjust the finder adjustment lever (page 29). • The mode dial is not set to , P, S, A, M, SCN p Set it to , P, S, A, M, SCN or or . (pages 27 and 100). 120