Sony FWD-32LX1R Operating Instructions - Page 22

Input Signal, Picture Mode and, Display Status Information

Get Sony FWD-32LX1R PDF manuals and user guides View all Sony FWD-32LX1R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Watching the Picture Input Signal, Picture Mode and Display Status Information Input signal and "Picture Mode" information appear on the screen for about twenty seconds when the power is turned on and for about five seconds when the input signal is switched. To disable this function, follow the steps below. 1 In the CUSTOM SETUP menu, press M/m to move the cursor (yellow) to "Display" and press ENTER. The following menu appears on the screen. CUSTOM SETUP Power Saving: Speaker Out: Closed Caption: Display: Color Matrix: HD Mode: RGB Mode: Sync Mode: Illumination: Remote Standard Off Off Off YO/nPB/PR 1080i DTV H/Comp High Select Set ENTER Exit MENU 2 Press M/m to set "Display" to "Off," then press ENTER. To display the information Set "Display" to "On" in step 2 above, then press ENTER. The factory default setting is "On." Note You can display the input signal information and the time anytime by pressing the DISPLAY button on the Remote Commander, regardless of the above setting. 22 (GB)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
22
(GB)
Watching the Picture
Input Signal, Picture Mode and
Display Status Information
Input signal and “Picture Mode” information appear
on the screen for about twenty seconds when the
power is turned on and for about five seconds when
the input signal is switched.
To disable this function, follow the steps below.
1
In the CUSTOM SETUP menu, press
M
/
m
to
move the cursor (yellow) to “Display” and press
ENTER.
The following menu appears on the screen.
CUSTOM SETUP
Power Saving:
Speaker Out:
Closed Caption:
Display:
Color Matrix:
HD Mode:
RGB Mode:
Sync Mode:
Illumination:
Remote
Standard
Off
Off
1080i
DTV
H/Comp
High
Set
ENTER
Exit
MENU
Select
Off
On
2
Press
M
/
m
to set “Display” to “Off,” then press
ENTER.
To display the information
Set “Display” to “On” in step
2
above, then press
ENTER. The factory default setting is “On.”
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.