Sony ILCE-3000K Operating Instructions - AC Adaptor AC-UB10C/UB10D

Sony ILCE-3000K Manual

Sony ILCE-3000K manual content summary:

  • 1
  • 2

1
2
3
4
5
English
Owner’s Record
The model and serial numbers are located on the bottom. Record the serial number in the
space provided below. Refer to these numbers whenever you call your Sony dealer regarding
this product.
Model No. ILCE-3000
Serial No. ______________________________
Model No. AC-UB10C/AC-UB10D
Serial No. ______________________________
IMPORTANT SAFETY INSTRUCTIONS
-SAVE THESE INSTRUCTIONS
DANGER
-TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, CAREFULLY FOLLOW
THESE INSTRUCTIONS
If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the
proper configuration for the power outlet.
Checking the supplied item
AC adaptor AC-UB10C/UB10D (1)
Charging the battery pack
Set the power switch to OFF.
Open the cover by sliding the lever.
Insert the battery pack completely, using the tip of the battery
to press the lock lever
(A)
.
Close the cover.
Connect the camera to the AC Adaptor (supplied) using the
micro USB cable
(B)
(supplied). Connect the AC Adaptor to the
wall outlet (wall socket)
(C)
.
Notes
When charging is finished, disconnect the AC Adaptor from the wall outlet (wall socket).
Be sure to use only genuine Sony brand battery packs, micro USB cable (supplied) and
AC Adaptor (supplied).
Charging time
The charging time is approximately 290 min. using the AC Adaptor (supplied).
Notes
The above charging time applies when charging a fully depleted battery pack (supplied)
at a temperature of 25°C (77°F). Charging time may take longer depending on conditions
of use and circumstances.
Using your camera abroad – Power source
You can use your camera and AC Adaptor in any countries/regions where the power supply
is within 100 V to 240 V AC, 50 Hz/60 Hz.
An electronic voltage transformer is unnecessary and its use may cause a malfunction.
Troubleshooting
The charge lamp on the camera flashes when charging the battery pack.
The charge lamp flashes in two ways, fast (about 0.3-second intervals) or slow (about
1.3-second intervals). If the charge lamp is flashing fast, remove the battery pack and
reattach the same battery pack securely, or disconnect and reconnect the USB cable. If
the charge lamp flashes fast again, it suggests that there is something wrong with the
battery pack, AC Adaptor (supplied), or USB cable. Slow flashing indicates that charging
is suspended because the ambient temperature is outside the suitable range for charging
the battery pack. Charging will resume and the charge lamp will be lit when the ambient
temperature returns to within the suitable temperature. The optimal temperature for
charging the battery pack is between 10 °C and 30 °C (50 °F and 86 °F).
Specifications
AC Adaptor AC-UB10C/UB10D
Power requirements: AC 100 V to 240 V, 50 Hz/60 Hz, 70 mA
Output voltage: DC 5 V, 0.5 A
Operating temperature: 0 °C to 40 °C (32 °F to 104 °F)
Storage temperature: –20 °C to +60 °C (–4 °F to +140 °F)
Dimensions: Approx. 50 mm × 22 mm × 54 mm (2 inches × 7/8 inches × 2 1/4 inches)
(W/H/D)
Mass (Approx.): 48 g (1.7 oz)
1.
2.
3.
4.
5.
2013 Sony Corporation
Printed in Thailand
4-477-464-
11
(1)