Sony KP-46WT520 Operating Instructions - Page 47
Programming the Remote Control - power supply
View all Sony KP-46WT520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
SETUP SETUP Remote Control Programming the Remote Control The remote control is preset to operate Sony brand video equipment. If you have video equipment other than Sony brand that you want to control with the TV's remote control, use the following procedure to program the remote control. ✍ The equipment must have infrared (IR) remote capability in order to be used with the remote control. 1 Turn to the list of "Manufacturer's Codes" on page 47, and find the three-digit code number for the manufacturer of your equipment. (If more than one code number is listed, try the number listed first.) 2 While holding down DVD/VCR FUNCTION or SAT/CABLE FUNCTION, press RESET. Then release both buttons. (The DVD/VCR FUNCTION and SAT/CABLE FUNCTION buttons will flash.) 3 Press either DVD/VCR FUNCTION or SAT/CABLE FUNCTION, depending on which button you want to program. 4 Enter the three-digit manufacturer's code number. 5 Press ENT. ✍ You must do step 5 within 10 seconds of step 4, or you must redo steps 3 through 5. 6 To check if the code number works, aim the TV's remote control at the equipment and press the POWER button that corresponds with that equipment. If it responds, you are done. If not, try using another code listed for that manufacturer. Notes ❑ If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment. ❑ If you enter a new code number, the code number you previously entered at that setting is erased. ❑ In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment's own remote control. ❑ Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reset. 46 SETUP SETUP SETUP