Sony PS-LX300USB Operating Instructions - Page 15
Troubleshooting, Playing a vinyl record - on
UPC - 027242731271
View all Sony PS-LX300USB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
To install the stylus Do this procedure with the stylus protected by the stylus cover. 1 Grasp both sides of the stylus holder, then insert the stylus grip into the cartridge/ headshell receptacle. Stylus holder Stylus cover Stylus grip 2 Push up the stylus holder until it clicks so that it locks completely. Do not leave any space. Note Do not push the stylus cover forcefully. Otherwise, the exposed stylus from the cover may cause injury, or damage the stylus. Troubleshooting Before going through the check list below, first make sure that: The power cord is securely connected. The speaker cords are securely connected. Should any problem persist after you have made these checks, consult your nearest Sony dealer. Playing a vinyl record The tone arm skips, skates or does not advance. The turntable is not level. Place the turntable on a level surface. The record is dirty or scratched. Clean the record with a commercially available record cleaning kit, or replace the record. Poor sound quality, excessive noise, intermittent sound, etc... The stylus is dirty or worn. Remove dust on the stylus using a stylus cleaning brush, or replace the worn stylus (see page 14). Dust or dirt has collected on the vinyl record. Clean the record using a good quality record cleaner. Additional Information Continued 15GB