Sony SPM-TRI/E Installation Manual

Sony SPM-TRI/E Manual

Sony SPM-TRI/E manual content summary:

  • Sony SPM-TRI/E | Installation Manual - Page 1
    ® INSTALLATION MANUAL Sony Electronics Inc. 16450 West Bernardo Drive San Diego, CA 92127 www.sony.com/plasma
  • Sony SPM-TRI/E | Installation Manual - Page 2
    the stand o Securing the plasma to the stand o tabletop must be capable of supporting at least five (5) times instructions must be adhered to. taken at all times. Contact Sony for any questions Warning and or any other source of direct heat energy. Failure to do so may result in
  • Sony SPM-TRI/E | Installation Manual - Page 3
    diagrams PART#: SPMTRI/E MATERIALS USED: 12 (GA) CRS, MDF Silver base COLOR: Silver A. Back plate B. Stand support C. MDF Silver Base D. Security access screws E. (1) Cable access hole F. Fixed tabletop mounting holes Dimensions are in Inch and mm 18.25 (463.5) 20.50 (520.7)
  • Sony SPM-TRI/E | Installation Manual - Page 4
    clear base. Secure the two (2) upright supports (flat surface facing out) to the base by using the four (6) M5 x 30 (mm) Phillip screws (supplied). CAUTION: Do not over tighten the screws. Uprights MDF Silver base (6) M5 x 30 Flat head screws Step 2 The stand fits a 32" 42" and 50" PFM series (Sony
  • Sony SPM-TRI/E | Installation Manual - Page 5
    Securing the plasma to the stand Step 3 Raise the display with the securing sleeves installed to the plasma. Slip the sleeves through the four (4) keyholes on the back plate and drop
  • Sony SPM-TRI/E | Installation Manual - Page 6
    . See figure 4. NOTE: This diagram shows the bottom of the stand. Wood screw access holes Step 2 OPTIONAL TABLE MOUNTING If securing to a wood table, mark the table and drill properly. Secure the stand with the two (2) #10 x 1-1/4" wood screws (supplied). NOTE: Longer or shorter wood screws and or
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

®
INSTALLATION MANUAL
Sony Electronics Inc.
16450 West Bernardo Drive
San Diego, CA 92127
www.sony.com/plasma