Sony STR-K502 Operating Instructions - Page 42

Recording Recording on a video tape You can record from a TV, or an LD player using the receiver. You can also add audio from a variety of audio sources when editing a video tape. See your LD player's instruction manual if you need help. 1 Select the program source to be recorded. 2 Prepare the component for playing. For example, insert the laser disc you want to record into the LD player. 3 Insert a blank video tape into the VCR for recording. 4 Start recording on the recording VCR, then start playing the laser disc you want to record. z You can record the sound from any audio source onto a video tape while recording from a laser disc Locate the point where you want to start recording from another audio source, select the program source, then start playback. The audio from that source will be recorded onto the audio track of the video tape instead of the audio from the original medium. To resume audio recording from the original medium, select the video source again. Notes • You cannot record a digital audio signal using a component connected to the analog MD/TAPE OUT or VIDEO OUT jacks. • Sound adjustments do not affect the signal output from the MD/TAPE OUT or VIDEO OUT jacks. • When MULTI CH IN is selected, audio signals are not output from MD/TAPE OUT or VIDEO OUT jacks. Using the Sleep Timer You can set the receiver to turn off automatically at a specified time. Press SLEEP on the remote while the power is on. Each time you press SLEEP, the time changes as shown below. n 2-00-00 n 1-30-00n 1-00-00 n 0-30-00 n OFF The display dims after you have specified the time. z You can freely specify the time First, press SLEEP on the remote, then specify the time you want using the jog dial on the receiver. The sleep time changes in 1 minute intervals. You can specify up to 5 hours. z You can check the time remaining before the receiver turns off Press SLEEP on the remote. The remaining time appears in the display. Other Operations 42